![]() ![]() If you’re not sure about your plans, reach out to our CASp Specialists to review your property or plans at MAKE SURE TO GET THE PROPER GRAB BAR LENGTHĪDA Code specified for many years that the parallel bar’s leading-edge next to the toilet must have 54 inches at least from the rear wall, while the rear edge should have 12 inches away from the wall. If a range is shown on the plans, the contractor should install the grab-bar in the center. The architect should dimension the grab-bars in the middle of the range on the plans. Even just a fraction of one inch may get you cited for noncompliance, depending on who the inspector is. Where many problems begin is where installers frequently aim for one edge of this range, and end up a bit too low or high per the Grab-Bar Accessibility Code. The bottom of a vertical bar in transfer showers must be 3-6 inches over the horizontal bar on the wall. In showers and toilets, the top of a horizontal grab bar must be 33-36 inches off the floor. Install the rear grab bar at least 24 inches from the toilet centerline on the open/transfer side.ĬAREFUL WHEN IT SIZING THE HEIGHT OF YOUR GRAB BARS. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |